Sinclair Manual Grommet Machine PG20 Uživatelský manuál

Model PG-20 Manual Grommet Machine Operating Manual (800) 624-2408 (530) 626-9386 Fax (530) 626-5144 6686 Merchandise Way Diamon

INTRODUCTION MANUAL MACHINE MODEL PG-20 FOR PLACING APPLICATIONS BY HAND The function of this machine is the placement of applications or to punch

Installation of PG-20 Install grommet machine on secure table top with the front of machine base flush with table edge. Use four bolts with lock nut

In order to adjust the grommet pressure. - Insert grommet on die #3 as shown in figure 1 below. Make sure bottom of grommet is up above bottom of t

Change Of Dies The PG-20 will take two die sets. If you want to change out sizes, you will need to replace parts. Please refer to the following diag

Parts Schematic

Schematic # Part # Description 30 PGR2030 Machine Head 31 PGR2031 Die Holder Pin 32 PGR2032 Driving Stem 33 PGR2033 Driving Stem Guide Wheel Pin

NOTES